Side Tank Accessory - GE OPAL01GEPKT El Manual Del Propietario

Ocultar thumbs Ver también para OPAL01GEPKT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Side Tank Accessory

Side Tank Quick Start
NOTE: There are two drain tubes located on the back of your Opal Nugget Ice Maker indicated as drain tube A and B
in the illustration on page 12.
1. H and Wash Only: Rinse and hand wash Opal Side
Tank with warm water and a mild dish soap. Remove
Opal Side Tank's cap and wash the cap and rubber
valve with water and a mild dish soap. The Side Tank
base can be washed by disconnecting the hose and
adding a small amount of soapy water to it. Scrub as
needed and rinse thoroughly. The rinse water should
drain out the port in the back.
Rinse the cap, rubber valve, tank and the base well to
remove any residual soap (see illustration).
DO NOT WASH THE SIDE TANK IN THE
DISHWASHER.
2. U nplug Opal Nugget Ice Maker. Unhook Opal's drain
tubes and drain the water from the reservoir.
3. C onnect drain tube, labeled B, to the back of Opal Side
Tank's base.
4. Make sure drain tube (A) is connected to the black
hanger and installed on the back of Opal.
5. M ake sure drain tube (B) connecting to the Side Tank
is resting flat on the countertop.
49-1000418 Rev. 2
Side Tank
Cap and
Valve
A
B
Unplug this
drain tube (B)
from the black
hanger and
connect this
tube to the
Side Tank.
Plug drain tube B
into the side tank
here.
11

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido