Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Step 1.
Identify all parts packed in carton against the parts list. Remove all protective materials. Place parts
on a non-abrasive surface to avoid scratching.
Step 2.
With the help of another person, place the table top (B) upside down on a flat, non-abrasive surface
to avoid scratching the top or rim. Attach table leg (A) to rim using M6x15 bolts (E) as shown in the
diagram. Guide the bolt through the hole in table leg into the pre-drilled hole in the table rim. Hand
tighten 3-4 revolutions only. Do not tighten completely. Some adjustments may be necessary to
ensure proper alignment of the table legs. Repeat this for another leg.
Step 3.
Attach table leg (A) to the leg connectors (C) using M6x22 bolts (D) as shown in the diagram. Hand
tighten 3-4 revolutions only. Do not tighten completely. Repeat this for another leg.
Step 4.
After making any necessary adjustments on the alignment of the table legs and leg connector,
use the hex bolt driver to tighten all bolts. Each bolt must be tightened a few revolutions at a time.
In order to apply equal pressure to all bolt joints, we recommend working in a cross corner ("X")
fashion. Repeat until all bolts are tight. Do not over-tighten, over-tightening may strip bolts.
F
E
A
B
F
D
A
C
1-866-771-2663 | Page 3
Publicidad
