9. Move throttle control lever (A) to "Fast" position,
shown on engine as a rabbit
10. Move choke lever (B) to "Choke"
B
NOTICE For a warm engine, be sure the choke lever is in
the "Run"
position.
NOTICE Before starting the pressure washer, be sure you
are wearing safety goggles as described below.
WARNING Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVER substitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
14
.
A
position.
NOTICE After each starting attempt, where engine fails to
run, always point gun in safe direction, press red button and
squeeze spray gun trigger to release high pressure.
NOTICE Always keep the throttle control lever in the "Fast"
11. Position yourself as recommended below, grasp recoil
handle and pull slowly until you feel some resistance.
Then pull rapidly to start engine. Return starter grip
handle slowly. DO NOT let rope "snap back" against
starter.
•
If engine starts, proceed to step 13.
•
If engine fails to start, proceed to step 12.
WARNING Starter cord kickback (rapid retraction) will
pull hand and arm toward engine faster than you
can let go which could cause broken bones,
fractures, bruises, or sprains resulting in serious
injury.
• NEVER pull starter cord without first relieving spray gun
pressure.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to release high pressure.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
12. If engine fails to start after six pulls, move choke lever
to "Run"
position, and repeat step 11.
13. When engine starts, slowly move choke lever to "Run"
position, as engine warms. If engine falters, move choke
lever to "Choke"
position, then to "Run"
position when operating the pressure washer.
position.
www.usa.husqvarna.com