Descargar Imprimir esta página

OWT Industries AP31024D Manual De Instrucciones página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

note: Make sure the tank is securely installed. Allowing
air into the injector during use may cause damage to your
pressure washer pump.
n Start the pressure washer as described in your pressure
washer manual and proceed to clean as desired.
note: One pouch of G-Clean detergent will last up to
30 minutes, depending on the flow rate of your pressure
washer.
n Use the dial on the G-Clean Detergent Injector to choose
water or G-Clean detergent as desired.
note: Any nozzle appropriate for use on your pressure
washer may be used with the G-Clean Detergent Injector
installed. See the following chart for standard nozzles and
applications.
nozzle
Second story detergent application
15º, 25º, 40º Regular surface deep cleaning
Soap
Low pressure detergent application
n When the injector looks empty and the water begins
to run clear, turn off your pressure washer and replace
the empty pouch with a new G-Clean detergent pouch.
Additional G-Clean detergent pouches are available at the
retailer where you purchased this product in the following
styles:
 Siding and All Purpose (green) ................... APGWC01
 Concrete Cleaner and Degreaser (orange) .. AGPWC02
 Mold Blaster (yellow) .................................. APGWC03
g-clean detergent injector
maintenance
See Figure 3.
n If a G-Clean detergent pouch is inserted but detergent is
not dispensed, check the dial to ensure that G-Clean is
selected. If it is, unscrew the injector head from the clear
detergent container and flush the screen with water.
n Before storing the G-Clean Detergent Injector, rinse to
remove any detergent residue and allow to dry completely
before reassembly.
application
oWt indUstries, inc.
Pickens, SC 29671
1-866-340-3912
unscrew tanK from cap to access
the screen for cleaning
Hwy 8
Fig. 3
988000-451
7-24-12 (REV:03)

Publicidad

loading