REV SA-IR07-NWX03-D Manual De Instrucciones página 8

GB
General information
Please thoroughly read the following operating instructions before
placing the device into service and keep for future reference. The bell
button is suitable for operation in protected outdoor areas and not in
harsh environments. The wireless chime is intended for installation in
dry indoor areas (IP20).
Notes
• The wireless chime is only designed for use with the appropriate batteries.
• To be able to use the Wireless motion detector, you will need a receiver
(bell) from the Orchestra range
• In combination with a receiver (gong), the motion detector offers you the
opportunity to set up a bell system without wiring.
• This set is not intended for integration into an existing bell system.
• The range between transmitter and receiver is maximum 100m in the open field
The radio signal is transmitted through walls, walls, furniture and other obstacles,
but depends on the structural conditions - walls, especially reinforced concrete
walls, heat-insulating glazing and ceilings lead to a reduction in range.
• Shielding caused by metal parts can severely impair reception, so that the signal
cannot be transmitted. For this reason, never attach the transmitter to metal
surfaces.
• If the product is not in use for a long period of time, remove the batteries.
• The product has no replaceable parts. Do not try to open or repair the product.
Technical Data
Range (free field):
Frequency:
Frequency band:
Max. transmission power:
Coverage angle:
Detection zone:
Time between 2 recordings:
Battery:
Degree of protection:
Degree of protection:
13
max. 100m
433,92MHz
433,05 – 434,79MHz
<10mW
approx.110°
approx. 4m
5 seconds
1x 3V C R2450 (included in delivery)
IP20 (for dry indoor use only)
Safety Extra Low Voltage
Safety Instructions for batteries:
• Incorrect polarity of the batteries can destroy the unit.
• Do not store batteries within reach of children, especially those that can be
swallowed.
• Do not attempt to reactivate batteries by heating or similar measures.
• Primary batteries must not be charged as this can lead to electrolyte leakage,
explosion or fire.
• Do not immerse batteries in water and store them in a dry and cool place, not in a
damp place.
• Do not throw batteries into the fire, do not open them or solder or weld them
yourself.
• Do not short-circuit batteries.
Function
The motion detector starts a recording of the area every 5 seconds. The blue
indicator goes on if a change in motion or temperature is detected in the
detection zone during the detection period. The sensor is triggered and sends
a signal to the receiver (chime), which indicates receiving the signal using a bell
tone.
Set up
Remove the assembly fixture on the rear side. Unscrew the cover on the battery
compartment of the motion detector. Remove the insulation strip in the battery
compartment. Then, close the battery compartment again.
Changing the batteries
Under normal conditions, the blue indicator blinks once, when the sensor is
triggered. If the battery status is low, the blue indicator blinks an additional 2
times quickly after the normal blinking.
To change the batteries, remove the assembly fixture on the rear side. Unscrew
the cover on the battery compartment. Replace the battery with a new battery of
the same type (refer to "Technical Specifications"). The positive pole is pointing
upwards. Then, close the battery compartment again.
The motion detector should be able to detect your movement immediately and
the chime should sound the bell tone.
14