Brita WHS - 101 Instrucciones De Instalación página 9

household filtration
Filter Replacement
(every 6 months)
n
f
h.
he
n
ing
Note: Place paper towels or rag under the filter housing to catch any water drips.
e
Before You Begin
ng
Unscrew
Step 1
Filter Housing
Clean
Step 2
Filter Housing
Clean and
Step 3
Lubricate O-Ring
n
Step 4 Insert New Filter
d
Step 5 Flush New Filter
*Note: To prevent leaks and/or housing ruptures, please properly seat filter cartridge at top and bottom within filter housing.
WHS-101 Installation Instructions
For FREE Filter Replacement Reminder, go to www.protectplus.com
• Turn off household water supply to the home .
• Turn on all faucets in home to drain water lines.
• Press the red pressure relief button.
• Use the wrench to remove the filter housing.
• Careful: Filter housing will contain water .
• Rinse filter housing.
• Fill 1/3 with water and add 2 tbsp. of Clorox® bleach.
• Wipe Head and Housing .
• Rinse Filter Head thoroughly to remove bleach.
• Remove and wipe clean o-ring .
• Lubricate o-ring with silicone grease .
• Return o-ring and seat securely for a good seal .
• Insert new Filter over standpipe in bottom of
Housing.
• Attach Housing to Head and hand tighten .
• Using the Wrench, tighten 1/4 turn .
DO NOT OVERTIGHTEN.
• Slowly turn on household water supply .
• Press red pressure relief button to release trapped air .
• Check for leaks.
• Open the faucet and flush for 40 minutes.
9 9
Version 2.0G