2
5
Install the remaining Hose Clamps
over the
4
open ends of the 1.5" Water Hoses connected
to the Solar Heating Mat. Insert the hose
adapters 2 over the 1.25" pump outlet and the
1.25" pool inlet fittings. Connect one hose
5
from the Solar Heating Mat to the pump outlet
and connect the other hose
to the pool
5
inlet fitting. Tighten the Hose Clamps.
Turn the knob of the control valve 1 to
divert the water to the Solar Heating Mat until
the desired water temperature is reached.
1. First, unplug the filter pump. Turn the handle of the Valve Body to stop water from flowing into the Solar Heater Mat.
2. Reverse the steps of installation to disconnect the Water Hoses from the Solar Heater Mat.
3. Reconnect the Water Hose from your pump outlet to the pool return fitting.
4. Squeezee the water out from the Solar Heater Mat.
5. Clean and dry all parts before storage.
1. Check the hose connections to make sure there is no leakage of water.
2. It is suggested to bypass the Solar Heater Mat when the desired water temperature is reached.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
16
8
5
Install the remaining Hose Clamps
4
open ends of the 1.5" Water Hoses connected to the
Solar Heating Mat. Connect the threaded fitting
adapters 8 to the pump outlet and pool inlet fittings.
Connect one hose
from the Solar Heating Mat
5
to the threaded fitting adapter 8 at the pump outlet
and connect the other hose 5 to the threaded fitting
adapter
at the pool inlet fitting. Tighten the Hose
8
Clamps.
20
DISASSEMBLY AND STORAGE
MAINTENANCE
MST. Extended operating days and hours during peak season requirements.
17
IMPORTANT: Remove the service plugs or
over the
open the shut-off valves before turning your
pump back on. Inspect the Solar Heating Mat
and all hose connections for leaks and
correct as needed.
OWNER'S MANUAL
18
Plug the pump back in (if unplugged) and press
the "Reset" button or the power switch to turn
the pump back on.
19