Tru EX-7000 Guia De Inicio Rapido

EX-7000™ TruElectrostatic Sprayer Quick Start Guide
NOTE: Prior to use, please lift the liquid tank from the power pack and remove the
cardboard insert. Then replace the liquid tank and follow the remaining Quick Start
Guide instructions.
CONTENTS: After unpacking, inspect the components for any damage or missing hardware
pieces, etc. The following components are included with your purchase:
1) Power Pack with Applicator
2) 3.1L Liquid Tank
3) Rechargeable Battery 14.4V (2 included)
1
Step 1: Install the Battery
Make sure the battery is fully charged (3 bars = full charge).
•
See instruction diagram below
•
Step 2: Liquid Tank Insertion
For the initial set up/test, fill the liquid tank 1/4 full with water.
•
Gently place the liquid tank in the power pack.
•
When the tank is completely inserted, it will lock/click into place.
•
Liquid Tank Removal:
Locate the tank latch toward the top center of the back panel of the power pack. Gently pull and hold the latch away from the
•
unit, this will release the tank.
With the latch pulled back, firmly grip the tank's handle and pull straight up.
•
Lift the liquid tank out of the power pack.
•
Step 3: Power Pack Harness Strap Adjustments
Put the power pack on like you would a backpack and adjust the straps to fit comfortably.
•
Step 4: Applicator Function Check
Once the applicator trigger switch is depressed, the clear LED on the back of the application will light up red.
•
Once the applicator trigger is released, the liquid will stop, and the fan will turn off this indicates the system is turned off.
•
2
4
4) Battery Charger
5) Backpack Harness
5
3