Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching Boerboel
8
a. Attaching the hinges to the inside of the gate
will allow the gate to open inward. When attaching
them to the outside, the gate will swing outward.
b. Mark and pre-drill
bottom upright. Secure using six 1
with the hinge) to front and side of the upright (Fig. 8).
Hold the gate level to the post, pre-drill holes with
9
bit and secure with six 1
Repeat for the bottom hinge.
NOTE:
Use 2" blocks to align the gate with the fence and help
hold the gate steady (Fig. 10).
Install Boerboel
10
a. Hold latch against the side of the post and
mark locations of pilot holes, as shown (Fig. 11).
b. Drill four
3
3
3
c. Place four 1" screws (provided with latch) through the
screw holes on the larger, side-surface of the post
plate (Fig. 12).
d. Place the four spacers onto the screws (on
the opposite side of the post plate), so they
will be between the post plate and the post
when post plate is mounted (Fig. 12).
e. Secure latch to side of post with four 1" Phillips
screws (Fig. 13).
Hinge To The Upright:
®
⁄
⁄
⁄
⁄ " pilot holes on top and
3
3
3
32
32
⁄ " screws to the post (Fig. 9).
⁄
⁄
⁄
1
1
1
2
2
Gate
Gate
2" Blocks
2" Blocks
Latch:
®
⁄
⁄
⁄ " pilot holes into the post.
⁄
32
32
⁄ " screws (provided
⁄
⁄
⁄
1
1
1
2
2
⁄ "
⁄
⁄
⁄
3
3
3
32
32
Fig. 10
Screws
Upright
Latch
Latch
Post
Post
Post Plate
Fig. 8
Fig. 9
Fig. 11
Fig. 12
Fig. 13
5
Publicidad
