Choose A Location - Honeywell Home RPWL4045A2000 Instrucciones De Instalación

Choose a Location

Choose a location that is not near a heat
source or on somthing that moves (like a
door).
Install Adapter
1. Pull the adapter apart from the wall plate.
2. Open the battery cover in the wireless adapter and install the
CR2032 battery.
3. Remove the existing doorbell chime from the wall.
4. Screw the wall plate to the wall using the included screws and
anchors (if not using the existing anchors).
Drill 1/4 inch holes for the anchors.
Wiring
1. Make sure at least 1/3-inch of each wire is exposed for easy
insertion into the wire terminals.
2. Insert the wires into the appropriate terminals. Refer to the
wiring diagrams below.
3. Connect the wires to the adapter terminals.
You can connect one or two doorbell pushes and
transformers.
A1/A2 Connect to one push button
B1/B2 Connect to a second push button (if used)
AC1 Connect to one line voltage transformer (if used)
AC2 Not used
4. When the wiring is complete, turn the power back on.
Wiring 1 (A only) or 2 (A and B) Pushes
B
A
Wiring 1 (A o/nly) or 2 (A and B) Pushes
with 1 Transformer
1/3 in.
B
A