Brizo BELO 63052LF Instrucciones De Instalación página 11

Custom Fit Connections - Plastic Sleeve Installation Instructions
Correct method
1. Identify desired length of tube (1). Leave 1" - 2"
of extra length to allow for easier installation and
cut tube. Ensure cut is straight and burr free.
2. Slide nut (2) and plastic sleeve (3) onto cut tube.
Ensure sleeve is oriented as shown.
3. Insert tube into outlet fitting (4). Tube should
touch bottom of hole inside fitting.
4. Slide plastic sleeve down tube until it engages
top of fitting. WARNING: Failure to use plastic
sleeve in the correct orientation will result in
disconnection and possible water damage.
5. Slide nut over plastic sleeve. With wrench,
tighten nut 2 turns past finger tight.
Incorrect Installation
Do not install sleeve
upside down.
77522 Rev. G
1
2
Do not use RP51243
gasket (1) supplied
with PEX tubing or
brass ferrule (2)
supplied with
valve stops.
Ensure cut is straight.
11
2
3
1
4
Ensure tube is fully
inserted into stop
before sliding sleeve
down to engage top
of fitting.