Troubleshooting; Cleaning And Care; Technical Data - OK. OCS 100BT-B Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
EN

TROUBLESHOOTING

Problem
Appliance does
not work.
No sound.
Bad audio
quality.
Remote control
does not work.
Appliance
does not react
to pressed
buttons.

CLEANING AND CARE

• Pull the power plug from the electrical outlets before cleaning.
• Clean the exterior with a lightly damp cloth.
• Do not use petrol, alcohol or other abrasive cleansers to clean the exterior.
• Do not allow liquids to spill into any openings.
• Use the original packaging if it is necessary to transport the unit.

TECHNICAL DATA

Power supply
Power supply:
Protection class:
Remote control:
Soundbar
Output power:
Speaker impedance (total):
Power consumption:
Frequency response:
Signal to noise ratio:
Dimensions (W x H x D):
IM_OCS 100BT-B_V06.indb 26
Possible cause
Power plug not connected properly.
Volume is set too low.
Sound is muted.
Settings at the source device are not
correct.
Bad Bluetooth reception.
Connecting cables are not inserted
correctly.
Battery empty or not correctly
inserted.
Distance between appliance and
remote control is too big.
Malfunction due to electrostatic
discharge.
220
240
II
3
V
1
15
W x
2
4
Ω x
2
+
30
W
40
Hz -
20
70
dB
950
x
93.5
26
Solution
Check if the power plug is properly
connected to an electrical outlet.
Increase the volume level.
Restore sound by pressing MUTE.
Ensure that the external source has correct
volume settings and is playing a track.
Shorten the distance between the
Bluetooth device and the appliance and
make sure that no obstacles are disturbing
the connection.
Ensure that the connector cables to the
source device are correctly plugged in and
plugs fully inserted.
Check that the battery is correctly inserted
or, if necessary, replace.
Reduce the distance between the remote
control and the soundbar and make sure
there are no obstacles between them.
Aim the remote directly at the Infrared
receiver on the soundbar.
Disconnect the appliance from the power
supply.
Connect the power plugs again to an
electrical outlet.
V~,
50/60
Hz
x
3
V Lithium button cell, type
+
30
W
8
Ω
kHz
x
51
mm
CR2025
(supplied)
1/3/2017 11:33

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido