Installing Remote Control Batteries; Programming The Remote Control; Code Scanning - Hughes DIRECTV GAEB0 Manual Del Usuario

Installing remote control
batteries
Programming the
remote control

Code scanning

16
Using the remote control
To install or replace the remote control batteries:
1. Locate the battery compartment on the back of the remote control.
2. Remove the battery compartment cover.
3. Insert two "AAA" size batteries as shown, observing the correct polarity.
4. Replace the battery compartment cover.
Installing batteries in the remote control
You can operate your TV, VCR, and Audio/Video receiver using your HRMC-8
or HMRC-9 remote control. Use the Code Scanning or Code Entry method to
program the remote control. Code scanning may be more time-consuming, but
you don't need to know manufacturer's control codes. Using the Code entry
method may be quicker, but you'll need to know the correct manufacturer's
control codes for each component you want to operate.
1. Aim your remote control at the component you want to use.
2. Hold down the desired device button (
3. Press the button for one second.
MUTE
4. Release both buttons together.
5. The device button (in this example, the
If the button does not light, repeat the previous steps.
6. Use one of the two programming methods described above.
To use this method:
1. Repeatedly tap the top part of the
2. Continue to step through the codes until the component turns off, indicating
you have found the correct component code. If you accidentally pass a code
that responds or realize you may not have been aiming the remote control at
the component, tap the lower part of the
backward through the codes.
3. Press the remote control
turning the device on and off.
4. Press the device button (in this example,
, for example).
TV
button) glows and remains lit.
TV
CHANNEL (CH)
CHANNEL (CH)
button to verify the proper code by
POWER
) again to lock in the code.
TV
button.
button to step