Control Panel; Remote Control - Taurus Alpatec ICE BRISE Manual De Instrucciones

English
PEDESTAL FAN
ICE BRISE
DESCRIPTION
A Front grill
B Grill ring
C Buckle
D Blade fasten nut
E Blades
F Grill fasten nut
G Back grill
H Motor shaft
I Motor cover
J Fan head
K Control panel
L Bolt
M Power cable
N Top tube
O Bolt
P Bottom tube
Q Base
R Gasket
S L-shape screw
T Remote control

CONTROL PANEL:

1 Oscillation / Timer selection
2 Speed selection
3 On/Off
4 LED display
5 Timer indicator

REMOTE CONTROL:

a Speed selection
b Timer
c On/Off
d Oscillation
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Fully extend the appliance's power cable befo-
re each use.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance if the accessories
attached to it are defective. Replace them
immediately.
- Do not use the appliance if the on/off switch
does not work.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Keep the appliance in a dry, dust-free place,
out of direct sunlight.
- Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the appliance.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the appli-
ance from operating correctly.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance to dry pets or an-
imals.
- Do not use the appliance to dry textiles of any
kind.
- Ensure that the appliance is level with respect
to the floor.
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.
- The appliance should be used with its base
fitted.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.