Asus V4 Serie Manual De Instalación página 4

Selecting the voltage
The system's power supply unit has a 115
V/230 V voltage selector switch located
beside the power connector. Use this
switch to select the appropriate system
input voltage according to the voltage
supply in your area.
If the voltage supply in your area is
100-127 V, set the switch to 115 V.
If the voltage supply in your area is
200-240 V, set the switch to 230 V.
NOTE: Refer to the system User Guide for the exact location of the voltage selector.
Removing the side cover and
front panel assembly
1. Remove the cover screws on the rear panel.
2. �ull the side cover toward the rear panel until its hoo��s disengage from the
chassis tab holes. Set the side cover aside.
3. Locate the front panel assembly hoo��s, then lift them until they disengage
from the chassis.
4. Swing the front panel assembly to the right, until the hinge-li��e tabs on the
right side of the assembly are exposed.
5. Remove the front panel assembly, then set aside.
Air duct duct

1
2
1
2
Chassis tab holes
Installation manual
3
4
4
3
4
3
4