Klarstein VAPOAIR ONYX Manual Del Usuario página 17

to humidity after 30 seconds.) Touch POWER button again to turn off the device.
Touch the AUTO button
until fourth speed for each touch. Touch the fifth times, it enters AUTO mode. In Auto
mode, the device determines the optimal humidity by the formula and starts to achieve.
When the current humidity less than the table showed humidity, it is in the third speed
operation. When the humidity arrived, the machine will be in the first speed operation.
The device checks the accordance of the temperature level and the humidity level every
1 minute.
Air temperature in °C
≤ 18
19-20
21-22
23-24
25-26
≥ 27
ION Mode
Touch ION button to turn on the anion generator. It shows the symbol on LED
display. Touch again to stop the function. Long press this button for 3 seconds to turn
on/off water tank light. ION button is not available when lack of water.
Heat Mode
Touch HEATING button
the symbol on LED display. Touch again to stop the function. Mist will become cool after
5~10 minutes.
Constant Humidity Mode
Touch CONSTANT HUMIDITY button
to 75%. Press once, it will increase by 5%. After setting expected humidity, LED display
blinks for 5 seconds, then switch to show current temperature. If current humidity is lower
than setting humidity, device will work in the third speed. If current humidity is higher
than setting humidity, device will stop humidifying and stay in sleeping state.
Note: During sleep state, ION and HEATING function are not available to select.
to out of AUTO mode and the mist start from first speed
Humidity in %
65
60
55
50
45
40
, the warm mist will come out after 10~15 minutes. It shows
,you may set the humidity arranged from 40%
EN
17