Controls; How To Use - Vornado GLIDE HEAT Guia Del Propietario

CONTROLS

POWER INDICATOR LIGHT
Red light illuminates to
indicate heater is on.
8
English

HOW TO USE

Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
MODE
Vornado Air LLC at 1-800-234-0604.
High Heat (II) 1500 watts
or Low Heat (I) 750 watts.
1. Position heater so airflow is
not obstructed.
2. Plug power cord into standard grounded
wall outlet.
POWER ON / OFF (O)
3. GLIDE HEAT has an adjustable axis to
direct the airflow where you want it.
Adjust the tilt up to 20 degrees by sliding
the easy-to-adjust head.
REAR MOUNTED
THERMOSTAT KNOB
4. The heater has rear mounted controls. Use the
toggle switch to select Low Heat or High Heat.
Red power indicator light located on front of
heater (at top of the heater inserted between
the grill and housing) illuminates to indicate the
heater is On. Set thermostat knob to highest
setting by turning clockwise. When room
reaches desired comfort level, turn thermostat
knob slowly counterclockwise until heat cycles
off.
5. If heater tips over, power will be cut to the
heater. The red indicator light will not illuminate
until you position the heater back in upright
position and power is restored.
9
English