Installing The Receiver - Caremaxx 90103 Manual Del Usuario

2.3 Installing the receiver

1. Place the receiver in the desired place.
2. Plug in the adaptor (or use batteries)
3. Set the volume using the volume
button .
4. Select the same channel as the camera
using the CH button .
5. Switch on the receiver using the On/
Off switch .
6. It is also
the receiver
Connect the AV cable to the AV-Out 
possible to connect
to your television.
on the receiver and the AV socket on
your television (yellow for video and
red for audio).
3 Alarm features
You are able to choose from three
separately configurable alarm features.
Select an alarm or switch the alarm off
using the alarm button .
You can choose from the following 4
options:
Off: Alarm is off.
Motion: Motion detector – the alarm
sounds
detected.
Sensor: Bed-wet alarm – the alarm
sounds
detected.
Sound: Noise detector – the alarm
sounds when noise is detected.
For each of the above options, you are
able to configure the sensitivity using the
sensitivity button :
Low: Low sensitivity
Middle: Normal sensitivity
High: High sensitivity
You must first connect the sensor if you want
to use the bed-wet alarm. Place the sensor
on the mattress, underneath the blanket.
Connect the sensor to the camera .
18
when movement
when moisture
is
is