Banner BBT HD1+ Manual Del Usuario página 5

BEFORE TESTING:
1. Before you test a battery in a vehicle, turn off the ignition, all accessories and
loads. Close all the vehicle doors and the trunk lid.
2. Make sure you have put 6 pcs 1.5V batteries into the battery chamber.
Oxyride batteries are not recommended because of the initial 1.7 Volt output.
If the 1.5V battery runs out of power, screen will show "POWER LOW".
Replace those 6 pcs 1.5V batteries before starting the test.
Note that nothing will be seen on the display until the tester is
connected to a vehicle battery.
3. Make sure the battery terminals are clean. Brush them if necessary. Clamp the
black load lead to the vehicle negative battery terminal. Clamp the red load
lead to the vehicle positive battery terminal. Please clamp on the lead part of
the terminal only. Clamping on the iron part of the terminal will lead to wrong
test results.
4. Paper load:
Open the clear cover. Insert paper to the paper feeding for auto running the
paper into printer
PAPER REPLACEMENT:
A. Open the clear cover.
B. Insert replaced paper roll into the paper feeding for auto running the paper into
the printer.
C. Pull the paper slowly and straightly from the paper roll in the chamber.
Version 04/2020 5