SICO 3 Serie Manual Del Propietário página 10

TURNAROUNDS AND LANDINGS
Landings and turnarounds are ADA requirements
for longer ramps systems. They are also used to
change the direction of travel as required to fit
within the building's dimensions; see the section
on planning the ramp layout.
1. Set up the stage unit(s) that will function as
the landing or turnaround at the desired
height. Refer to the operating manual
provided with that product for additional
information regarding that product. If two 3'
x 8' [0.91 x 2.44m] folding leg units serve as
the turnaround, connect them to each other
with the rotolocks.
2. Attach the lower clamp assembly to the edge
of the landing or turnaround where the upper
ramps sections will connect; the clamp
attaches the same way the upper clamp was
installed.
3. Attach an upper clamp assembly to the
edge of the landing or turnaround in the
location where the lower ramp sections will
connect to the landing or turnaround.
4. Move the landing or turnaround so the lower
clamp assembly is adjacent to the bottom
edge of the ramp section that has already
been set up.
5. If necessary, adjust the glides in the landing
or turnaround and the ramp section until the
heights match.
LOWER CLAMP ASSEMBLY ATTACHED TO RAMP
LANDING
RAMP LANDING CONNECTED TO RAMP WITH
LOWER CLAMP ASSEMBLY
RAMP LANDING
PAGE 10