Aqua Marina BETTA BE-312 Guía De Usuario página 8

INFLATE THE KAYAK
Inflate the side chambers, air floor and inflatable keel at the bow in sequence as
shown in the picture.
1. Attach the pump hose to the pump and secure it tightly.
2. HIGH PRESSURE VALVE
Unscrew the valve cap, push button in and turn it clockwise to make sure that the
valve is in the "Pin Out" position.
FLOOR AIR VALVE
Open external cap and pull firmly to extend out.
3. Start pumping air into the kayak. Keep inflating until the required air pressure is
reached. DO NOT OVERFILL. Once inflated, firmly cap each valve.
TIP: If the pump piston starts to squeak, apply some spray silicone on the piston shaft.
TIP: Working pressure of each part should NOT exceed the maximum as below.
Side Chambers
BETTA 1.45psi / 0.1bar
STEAM
1.45psi / 0.1bar
IMPORTANT!
For BETTA, please use the transparent scale (come with
the repair kit bag) to check if the kayak floor is properly
inflated. The black line should NOT be longer than the
MAX. scale.
PARTIALLY INFLATE THE SIDE CHAMBERS AND THE KAYAK FLOOR
AND CHECK THAT THE FLOOR IS TUCKED UNDERNEATH THE SIDES.
C
BETTA
STEAM
Floor
Refer to the transparent scale.
4.35psi / 0.3bar
8
Keel
/
4.35psi / 0.3bar
IMPORTANT!
Please use the scale
transparency (come with the
repair kits bag) to check if the
kayak floor is properly
inflated. The black line in
below should NOT be longer
than the MAX. scale.