MaxPro MPID710V Manual Del Usario página 7

place, turn the drill chuck key (7) in a clockwise direction. Important: Then remove the key (7) from the
chuck (1)!
3
Working with the Drilling Machine
Ensure that the mains power supply voltage is the same as the operating voltage of your machine. For
details, please see the type plate. Insert the correct drill for the type of job to be performed. If necessary,
adjust the bit stop. Adjust the speed of the machine using the regulating wheel on the operating switch
(6). The more the operating switch (6) is pressed in, the faster the drill rotates. Set the direction switch (4)
to the desired direction of motion. Never alter the position of the percussion drilling switch (3) or the
direction switch (4) when the machine is switched on. The machine is switched on by pressing the
operating switch (6). When the operating switch (6) is released, the machine stops. If you would like to
use continuous operation press the locking button (5) while the operating switch (6) is pressed. In order
to switch off the machine during continuous operation, press the operating switch (6) again and then let
it go. Do not touch the drill chuck (1) while the machine is switched on.
Drilling Tips
1. Always insert the correct size and type of drill or screwdriver.
2. Set the machine to the correct speed.
3. Always hold the machine tightly by the handle and second handle (2).
4. When drilling wood and metal, set the percussion-drilling switch (3) to drilling.
5. When drilling masonry, set the percussion-drilling switch (3) to percussion drilling.
6. When using the machine as a screwdriver, set the percussion-drilling switch (3) to drilling.
Set the direction switch (4) to the correct direction.
7.
Never change the direction of motion when the machine is switched on.
8.
Overload
Never use excessive force when drilling. Too much pressure reduces the speed of the machine, and the
required power is greatly reduced. This may result in overload, which can damage the motor of the
drilling machine. When the drilling machine becomes too hot, allow it to run for two minutes without a
load and then interrupt working for a short time. Clean the drilling machine with a clean cloth and a
brush. Ensure that the ventilation slits are not blocked.
7
I I mpact Drill MPID710V User Manual
GB