Vacuum Cleaning; Replacing The Dustbag - Philips City FC8408 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 22
1
Lift the handle on the vacuum cleaner to gain access to the accessory storage compartment
(fig. 10).
2
Connect the crevice nozzle to the tube or directly to the handgrip.
3
The brush nozzle can be used for cleaning computers, bookshelves etc. (fig. 11).The small
nozzle can be used for vacuum cleaning small areas, e.g. the seats of chairs and sofas (fig. 12).

Vacuum cleaning

1
To carry the appliance, put the handle in upright position and lift the appliance by the handle
(fig. 13).
Adjusting suction power
You can adjust the suction power during vacuum cleaning:
1
Adjust the suction power by means of the electronic suction power control (specific types
only) (fig. 14).
Infrared remote control (specific types only)
1
Place the batteries in the battery compartment (fig. 15).
Make sure the - and + poles are pointing in the right direction.
2
With the infrared remote control you can set the suction power to one of 5 different suction
power settings.When you switch the appliance on, it will always start running at the highest
suction power setting (fig. 16).
3
By pushing the - button, you will reduce the suction power by one setting. By pushing the +
button, you will increase the suction power by one setting (fig. 17).
4
Push the standby button to temporarily switch the vacuum cleaner off, for instance when you
have to move some furniture.To continue vacuum cleaning, simply press the - button or the +
button.The appliance will start operating at the previously selected suction power setting
again (fig. 18).
Storage
1
Put the appliance in upright position and attach the lower tube to the appliance by means of
the clip (fig. 19).
The height of the clip can be adjusted by sliding it along the tube.

Replacing the dustbag

Replace the dustbag as soon as the "dustbag-full indicator" changes colour (when the nozzle
is not placed on the floor).
1
Switch the appliance off.
2
Open the cover (fig. 20).
3
Push the dustbag holder backwards (fig. 21).
4
Remove the full dustbag from the holder by pulling the cardboard tag (fig. 22).
When you do this, the dustbag will be automatically sealed.
5
Slide the cardboard front of the new dustbag into the two grooves of the dustbag holder.
Press it down as far as possible (fig. 23).
6
Pull the dustbag holder forwards (you will hear a click) (fig. 24).
You cannot close the cover if no dustbag has been inserted.
ENGLISH
7

Publicidad

Tabla de contenido
loading

Tabla de contenido