Basic Setup; System Requirement; Front Panel; Rear Panel - IRIS RC8221 Manual Del Usuario

RC8221 Iris
™
Camera
Chapter 2

Basic Setup

This chapter provides details on how to setup and mount the camera.

System Requirement

The Iris™ camera requires the Iris™ smart hub for operation. To use the wireless
interface on the wireless model, other wireless devices must be compliant
with the IEEE802.11b, IEEE802.11g or IEEE 802.11n specifications. All Wireless
stations must use compatible settings.

Front Panel

1. Lens
2. Infrared Motion Sensor
3. Privacy LED

Rear Panel

1. LAN port
2. Power Input
3. External Input/Output
4. Memory Card Slot
No physical adjustment is required or possible for the lens, but you should
ensure that the lens cover remains clean. The image quality is degraded if
the lens cover is dirty or smudged.
The infrared motion sensor is designed for human body detection.
On (Green) - The Privacy function is enabled.
Off - The Privacy function is disabled.
Use a standard LAN cable to connect your Network camera to a
10/100BaseT (or faster) Ethernet router or switch.
The LAN cable should only be connected or disconnected when the
camera is powered OFF. Attaching or detaching the LAN cable while the
camera is powered on does NOT switch the interface between wired and
wireless.
The LAN cable is only used while pairing the camera to Iris™. After
pairing is complete, the LAN cable is no longer required for video data
transmission. Please visit lowes.com/iris to learn more about pairing your
camera with Iris™.
Connect the supplied 12V power adapter here. Do not use other power
adapters; doing so may damage the camera.
GPIO terminal block including 1 input port and 1 output port.
The GPIO block is NOT used by Iris™.
The memory card slot is not used with the Iris service and is disabled for all
installations.
2