Panel Mounting - EMKO EZM-XX50 Serie Manual Del Usuario

PANEL MOUNTING

2
4 4
1
3
5 5
1- Before mounting
device in your panel,
makesure that the panel
cut-out is suitable.
2- Check front panel gasket
Position.
3- Insert the device through
the cut-out. If the mounting
clamp are on the unit, put
out them before inserting
the unit to the panel.
4- Insert the unit in the panel
cut-out from the front side.
5- Insert the mounting
clamps to the holes that
located top and bottom
sides of device and screw
up the fixing screws until
t h e u n i t c o m p l e t e l y
immobile within the panel.
the
6