TriplePlay VT Instrucciones De Aplicación

DESCRIPTION: Shoulder orthosis, acromio/clavicular (canvas and webbing type,) prefabricated. The orthosis has two (2) chambers that fill from
the distal upward toward the proximal end of the extremity.
1. Remove optional gel pack and place in freezer for a minimum of 1 hour.
NOTE: Each time the gel wrap thaws, refreeze for 1 hour.
2. Remove gel pack from freezer and re-attach to the inside of the wrap.
Make sure to keep a protective thin cloth barrier between the skin and
gel pack.
3. Thread arm through lower loop, and pull wrap up onto shoulder.
Secure the middle strap around arm, and tighten lower and middle
straps to acheieve a snug fit. Take the longer strap and thread through
the back clip so that it attaches across the back, under the unaffected
arm and across the chest. Thread through clip and secure with tabs.
4. Once the wrap is on, secure the optional immobilizing sling to the front
Valve and
Connector
Removable
Gel Pack
Immobilizing
Sling
For questions about this product call: 800.994.0464
www.CompressionSolutions.us
TP-5555 IFU REV11
Triple Play VT
APPLICATION INSTRUCTIONS
1
Re-attach
Gel Pack
4
Valve Operation
Disconnect
Valve
MODEL #:
T P - 5 5 5 5
– Universal Shoulder Orthosis
®
portion of the wrap. Place your wrist through the loop so that it
comfortably approximates the arm at a 90° angle.
5. Refer to the QuickStart Guide or Instructions for Use included
in the Triple Play VT packaging for instructions on operating the
unit with orthotic wrap.
NOTE: Ensure that the valve switch on the wrap is in the ON
position (vertical) before powering on TPVT unit.
6. Once the pressure is reached, you may choose to hold the
pressure by closing the valve on the connector by turning the
valve lever perpendicular (or 90˚) to the hose line. If desired,
the hose can be disconnected from the wrap by twisting the
disconnect valve connector to the left.
2
6
Open
Valve
Closed
Valve
OPTIONAL HAND BULB
Your product is provided with an optional hand
bulb which can be used to inflate/deflate the
wrap in the absence of the Triple Play VT unit. If
you desire, you may use scissors to cut the
tubing just below the insertion into the wrap.
Then place the barbed connector on the bulb
into the tubing connected to the wrap.
3
Protective
Barrier