Publicidad
Idiomas disponibles
Idiomas disponibles
Scrubbing/Cleaning the floor
• Ensure that the scrubbing brushes are attached
to the product (see page 5).
• Turning the machine on.
• With your foot securing the head of the polisher
on the floor (1), pull the handle towards you (2)
and the machine will start (Fig.8).
• Move the machine slowly across the surface of
the floor to loosen and collect any debris.
• Collect large debris towards the center of the
base unit to prevent it from being spread across
the floor.
• Once this is complete, turn the machine off
before returning it to its upright position.
Polishing the floor
• Clean floor thoroughly first before adding your
chosen floor polish.
• Allow to dry before buffing using blue buffing
pads.
• With your foot securing the head of the polisher
on the floor, pull the handle towards you and
the machine will start (see Fig.8).
• If you are using a floor polishing wax or oil, refer
to the manufacturer's instructions when using
with the Bissell BigGreen Commerical Hercules
Scrub and Clean
• Move at a speed of about 1 minute every
1m
and follow the diagram for an even finish
2
(Fig.7).
• Do not leave the machine operating in one
area for a prolonged period as this may
damage your floor.
Power Cord Storage
• The electrical power cord can be stored on the
rear of the product using the convenient power
cord storage hooks.Scrubbing /Cleaning the
floor
Fig.8
2.
Pull back
to start
7
1.
Place foot
on base
Publicidad
