Publicidad
Idiomas disponibles
Idiomas disponibles
8. Allow the vacuum to cool, then remove ash from the canister and clean the fi lter as explained in the
manual's "MAINTENANCE" instructions before storing the vacuum.
Usage Hints
• Do not shove or bury the nozzle in the ash; doing so will cause nozzle & hose to more easily clog
with debris.
• Rest the nozzle tip on the fi rebrick at roughly a 45
the nozzle & hose.
• Move the nozzle on the fi rebrick in a circular or back & forth motion. This will help scrap off ash
stuck to the fi rebrick and allow ash to be removed quickly through the nozzle & hose without
clogging.
• Move larger chucks of debris to the side to break apart between the metal nozzle and fi rebrick as
necessary.
DRY SHOP VACUUM USE
CAUTION:
Empty all ash from the canister and clean ash from fi lter before using
to vacuum up other types of material. Not doing so could increase the risk of fi re by
depositing combustible material into the canister.
1. Before connecting the power cord to power source, check that the canister & fi lter have been cleaned
of ash and the vacuum is properly assembled with the metal nozzle in place.
2. Ensure the On/Off switch is in the "O" (OFF) position.
3. Insert the power cord plug into an outlet near the area to be vacuumed, then push the switch to the "I"
(ON) position.
4. Occasionally check the FULL indicator during use.
5. Run the vacuum for about 30 seconds after cleaning is complete to be sure any material remaining
in the hose is safely deposited into the canister. Move the vacuum switch to the OFF position, then
unplug from the outlet.
6. Clean the canister and fi lter as explained in the manual's "MAINTENANCE" instructions before storing
the vacuum.
BLOWER USE
WARNING:
•
Always wear safety eye wear complying with ANSI Z87.1 (or in Canada, CSA
Z94.3) before using as a blower.
•
To reduce the risk of injury to bystanders, keep them clear of blowing debris.
•
Wear a dust mask if blowing creates dust that might be inhaled.
•
To reduce the risks of hearing damage wear hearing protectors when using the
vacuum/blower for extended hours or when using in a noisy area.
1. Before connecting the power cord to power source, check that the canister & fi lter have been cleaned
of ash and the vacuum is properly assembled.
2. Ensure the On/Off switch is in the "O" (OFF) position.
3. Locate the exhaust port. Install the large hose end and rotate clockwise to lock in place. Figure 6
NOTE:
When using Ash Vacuum as a blower, the hose can be used with or
without the metal nozzle or extension tube(s) installed
4. Insert the power cord plug into an outlet near the area to be vacuumed, then push the switch to the "I"
(ON) position.
English
°
angle to minimize larger pieces from clogging
9
Publicidad
