Dahle ShredMATIC Manual Del Usuario página 7

1
en Instructions
IMPORTANT!
Read the operating and safety instructions
BEFORE placing the document shredder
into operation.
You must follow the instructions.
Keep the operating instructions in a safe
place ready for later use.
Table of Contents
1 Important information . . . . . . . . . . . . . . . . 7
1.1 Intended use, warranty . . . . . . . . . . . . . . . 7
1.2 Safety instructions . . . . . . . . . . . . . . . . . . 8
1.3 Key to pictograms . . . . . . . . . . . . . . . . . . . 8
1.4 Scope of supply . . . . . . . . . . . . . . . . . . . 88
1.5 Technical specifications . . . . . . . . . . . . . . 88
2 Operation . . . . . . . . . . . . . . . . . . . . . . . . 89
2.2 Connecting the device to the power supply . 89
2.3 Switching on the device . . . . . . . . . . . . . . 89
2.4 Paper shredding . . . . . . . . . . . . . . . . . . . 90
2.10 CD, DVD & card shredding . . . . . . . . . . . . . 92
3 Maintenance / troubleshooting . . . . . . . . . 94
3.1 Emptying shredding waste . . . . . . . . . . . . 94
3.4 Overheated . . . . . . . . . . . . . . . . . . . . . . . 95
3.5 Overload . . . . . . . . . . . . . . . . . . . . . . . . 95
3.15 Cleaning the shredder . . . . . . . . . . . . . . . 98
1.1 Intended use, warranty
The document shredder is intended to be used for
shredding paper.
Depending on the model variant, a small amount of
the following materials can also be shredded:
- CDs/DVDs, bank cards and credit cards (see techni-
cal data).
- The normal staples and paper clips found in paper
documents (exception: security level P6 and P7
devices).
Wear, damage due to improper use or unauthorised
modifications and repairs are not covered by the
warranty or the guarantee.
The document shredder was designed for private use
and for use in normal office environments.
The following conditions apply to the performance in
terms of sheets listed under technical data:
Maximum number of sheets that are shredded in one
pass under the following conditions: New cutting roll-
ers, oiled if needed, cold motor, power supply with
nominal voltage and nominal frequency (230 V/50 Hz;
120 V/60 Hz). Deviations may result in reduced sheet
processing and increased operating noises.
The sheets are fed centrally and lengthwise at a 90
degree angle. The performance in terms of sheets
can also vary depending on the paper properties and
input.
7