Publicidad
Enlaces rápidos
a
b
i
h
m
NOTE: Hardware included for installation into drywall or plaster 1/2" to 5/8" thick. Other wall types
require additional hardware. See "Wall Types" section to determine hardware needs.
NOTA: Se incluyen herrajes de instalación para muro seco o yeso de 1,2 cm a 1,5 cm. Otros tipos de
paredes requieren herrajes de instalación adicionales. Vea la sección "Tipos de Paredes" para
determinar que tipo de herrajes necesita.
d
c
f
j
k
n
®
Before You Begin
1. Remove product from packaging and carefully inspect all parts.
(See Parts List below.)
2. Please read all instructions carefully before beginning.
Antes de Empezar
1. Saque el producto del paquete y cuidadosamente inspeccione
todas las partes. (Vea la lista de partes abajo).
2. Lea todas las instrucciones cuidadosamente antes de empezar.
Parts List
e
a. Wardrobe shelves—long (3) 02-4300
b. Storage shelves—short (3) 02-45640
c. Support pole (4) 01-699
d. Shelf end caps (56) 01-603/604
e. Wall clip (35) 01-40991
g
f. Side wall bracket (3) 01-40984
g. Pole end cap (4) 01-244
h. 1/2" phillips head screw (12) 01-215
i. Pole clips (12) 01-40977
j. Pole connector (2) 01-4307
k. 1" pins (35) 01-658
l. Shoe support bracket (2) 01-40913
m. Shoe rack (1) 02-45640
n. Pre-loaded Anchor (6) 01-50955
l
Lista de Partes
a. Repisas colgadoras—largas (3) 02-4300
b. Repisas de almacenaje—cortas (3) 02-45640
c. Postes de soporte (4) 01-699
d. Tapones para repisa (56) 01-603/604
e. Fijadores de pared (35) 01-40991
f.
g. Tapones de poste (4) 01-244
h. Tornillos de cabeza phillips, 1,2 cm (12) 01-215
i.
j.
k. Clavijas de 2,5 cm (35) 01-658
l.
m. Repisa para zapatos (1) 02-45640
n. Tarugos precargados (6) 01-50955
8' - 10' (2,44 m - 3 m)
Closet Organizer
Installation Instructions
Organizador de Clóset
Instrucciones de Instalación
Tools and Materials
Herramientas y Materiales
1/4" (6 mm)
Philips Head
Soportes laterales (3) 01-40984
Fijadores de poste (12) 01-40977
Conectadores de poste (2) 01-4307
Soporte para repisa para zapatos (2) 01-40913
#1610
TM
Publicidad
Manuales relacionados para ClosetMaid 1610
Resumen de contenidos para ClosetMaid 1610
- Página 1 #1610 ® 8' - 10' (2,44 m - 3 m) Closet Organizer Installation Instructions Organizador de Clóset Instrucciones de Instalación Tools and Materials Herramientas y Materiales 1/4" (6 mm) Philips Head Before You Begin 1. Remove product from packaging and carefully inspect all parts.
- Página 2 Prepare Hardware 1. Determine top of each pole by locating hole closest to end. 2. Attach an endcap to top of one pole and bottom of other pole. Repeat for second set of poles. Bottom 3. Attach pole clips to each set of poles with 1/2" screws (provided) Parte Parte as shown.
- Página 3 Measure and Fit This closet organizer is designed to fit a maximum opening of 10 feet. No cutting or adjustments are necessary for closets 10 feet wide (skip to steps 3-4 and follow measuring diagrams below). For closets less than 10 feet wide, the Wardrobe (long) shelves must Do not cut here! be cut to size.
- Página 4 Wall Types Wall type will determine installation requirements for wall clips. Please read the following instructions carefully. 1. Drywall and Plaster— Pins are required for installation in standard drywall (most drywall is 1/2" to 5/8" thick). Drill 1/4” holes into wall and use supplied pins. If drywall or plaster is more than 5/8" thick, drill 1/4" holes 1" deep and use #8 x 1"...
- Página 5 Install Support Poles 1. Place a support pole at each end of center shelf. 2. Firmly push all shelves into pole clips. Instalación de los Postes de Soporte 1. Ponga un poste de soporte en cada extremo de las repisas del centro.
- Página 6 BUYER'S REMEDIES and LIMITED WARRANTIES and exclude warranties of MERCHANTABILITY and FITNESS FOR A PARTICULAR PURPOSE. These controlling terms can be found in any Clairson catalog or by internet access. Copies are also available upon request by calling Clairson toll-free. © 2001 ClosetMaid, Ocala, FL 34478-4400 U.S.A. 01-84106...