Self-Cleaning Function - Taurus ATLAS 2400 CERAMIC Manuel De Instrucciones

SPRAY:
- The spray can be used in both steam and dry
ironing.
- Press the spray button ( A ) to use this opera-
tion.
- The spray button has to be pressed repeatedly
to release the first spray.
STEAM BLAST:
- This function proportions extra steam for elimi-
nating wrinkles.
- Press the steam blast button (B). Wait a few
seconds until vapour penetrates the fibres of the
garment before pushing the button again. For
optimum steam quality, do not apply more than
three successive blasts.
- The spray button has to be pressed repeatedly
to release the first spray.
VERTICAL STEAMING
- It is possible to iron hanging curtains, items of
clothing on his hanger, etc. To do so, follow the
instructions:
- Select the maximum temperature of the iron,
while turning the temperature regulator of the
iron in a clockwise direction (Fig 2).
- Move the iron in a top to bottom direction while
pressing the steam control ( B ). Important: for
cotton and linen, its recommended to put the
iron base in contact with the material. For other
more delicated fibres, it's recommended to keep
the iron base at some centimetres of distance.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Select the minimum position (MIN) using the
thermostat control.
- Unplug the appliance to the mains.
- Remove the water from the water tank.
- Clean the appliance
CLEANING
- Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.

SELF-CLEANING FUNCTION:

- It is important to self-clean the appliance at least
once a month to remove calcium and any other
built-up minerals inside the iron.
- Fill the depository to its maximum level, as
indicated on "water fill" section.
- Place the iron in a vertical position, plug in to
the mains and select the maximum temperature.
- Leave the appliance to heat up until the pilot
light indicates that it has reached its consigned
temperature.
- Unplug the appliance and place in the sink.
- Press the self-clean button, and keep it pressed
down.
- Let the water flow out through the steam vents
in the base, while lightly shaking the appliance.
- Release the button after a minute or when the
tank becomes empty.
- Leave the iron in the vertical position until it has
cooled.
* HOW TO DEAL WITH LIME SCALE INCRUS-
TATIONS:
- For the appliance to work correctly it should be
kept free of lime scale or magnesium incrusta-
tions caused by the use of hard water.
- To prevent this kind of problem, we recommend
the use of water with low lime or magnesium mi-
neralisation.
- Homemade solutions are not recommended for
de-scaling this appliance, such as the use of vi-
negar.