Getting Started; Resetting The Unit; Detaching The Front Panel - Sony CDX-C460 Manual De Instrucciones

Getting Started

Resetting the unit

Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the reset button with a pointed object,
such as a ball-point pen.
Reset button
Notes
• Pressing the reset button will erase the clock and some
memorized functions.
• When you connect the power supply cord to the unit or
EN
reset the unit, wait for about 10 seconds before you insert
a disc. Do not insert a disc within these 10 seconds;
otherwise, the unit will not be reset, and you will have to
press the reset button again.

Detaching the front panel

You can detach the front panel of this unit to
prevent the unit from being stolen.
1
Press (OFF).
2
Press (RELEASE) to open up the front
panel. Then slide the font panel a little
to the left, and pull it towards you.
(RELEASE)
Notes
• Be sure not to drop the panel when detaching it from the
unit.
• If you press (RELEASE) to detach the panel while the
unit is still on, the unit will turn off automatically to
prevent the speakers from being damaged.
• When you carry the front panel with you, put it in the
supplied front panel case.
4
(OFF)
Attaching the front panel
Align part A of the front panel to part B of
the unit as illustrated, and push until it clicks.
B
Notes
• Be sure not to attach the front panel upside down.
• Do not press the front panel hard against the unit when
attaching it. Press it lightly against the unit.
• Do not press hard or put excessive pressure on the
display window of the front panel.
• Do not expose the front panel to direct sunlight, heat
sources such as hot air ducts, and do not leave it in a
humid place. Never leave it on the dashboard of a car
parked in direct sunlight where there may be a
considerable rise in temperature.
Caution alarm
If you turn the ignition key switch to the OFF
position without removing the front panel, the
caution alarm will beep for a few seconds
(only when the POWER SELECT switch is set
to the A position).
If you connect an optional power amplifier and
do not use the built-in amplifier, the beep tone
will be disabled.
A