Safety Precautions - Sunstech DTBP470 Manual De Usuario

As a switching equipment, power adaptor should be convenient for operating
the device should be far away from water dropping and splashing, as well as vase full of
liquid
The password might require while you try to modify some advance option.
Default password is "0000".

Safety Precautions

Read the following recommended safety precautions carefully.
Power Source
Before plugging in for the first time, read the following section carefully.
This device should be operated only from a 220-240V AC, 50 Hz outlet.
Be sure that the power supply voltage of the area be used meets the required voltage and you select
the correct voltage setting for your device.
Power Cord
Do not place the set, a piece of furniture, etc on the power cord or pinch the cord. Handle the power
cord by the plug. Do not unplug the appliance by pulling from the power cord and never touch the
power cord with wet hands as this could cause a short circuit or electric shock.
Never make a knot in the cord or tie it with other cords. The power cord should be placed in such a
way that they are not likely to be stepped on. A damaged power cord can cause fire or give you an
electric shock. When it is damaged and needs to be replaced, it should be done by qualified
personnel.
Moisture and Water
Do not use this device in a humid and damp place (avoid the bathroom, the sink in the kitchen, etc).
Cleaning
or covered in anyway. When installing this unit make sure to leave space sufficient around the unit to
ensure the ventilation to improve heat radiation.
Do not expose the unit to extreme conditions of heat, cold or moisture
Heat and Flames
Do not expose this device to rain or water, as this may be dangerous and do not
place objects filled with liquids, such as flower vases, on top.
If any solid object or liquid falls into the cabinet, unplug the connected device(s)
immediately and have it checked by qualified personnel before operating it any
further.
Before cleaning, unplug this device from the wall outlet. Do not use an aggressive
liquid or aerosol cleaners. Use a soft and dry cloth.
Ventilation
The slots and openings on the device are intended for ventilation and to ensure
reliable operation. To prevent overheating, these opening must not be blocked
The device should not be placed near to open flames or sources of intense
heat such as an electric heater. Ensure that no open flame sources, such as
candles, are placed on top of the device. Batteries should not be exposed
to excessive heat such as sunshine, fire or the like.
2