Super Power YR-BC430B Manual Del Usuario página 71

The protective guard on this tool cannot stop objects that ricochet off hard surfaces.
WARNING
Do not trim in places where there are wires and wire mesh. Use protective aids. Do not
trim in locations where you cannot see what the trimmer is trimming.
CUTTING USING THE BLADE
CUTTING WEEDS
• This is cutting performed by a pendular movement of the blade in an arch
shape. In this way you can quickly clear a large area of dense grass and weed.
Brush cutting should be used for cutting large and tough weeds or woody
vegetation.
• Brush cutting may be performed in both directions or only in one direction,
which will mean that the cut material will be ejected away from you. With this
type of cutting, the part of the blade moving away from you will do the work.
Slightly tilt the blade down to the same side. If you will be brush cutting in both
directions, you will be hit by some deflected material.
N : Do not use the brush cutter blade for cutting trees with a diameter larger
OTE
than 12 mm.
WARNING
DO NOT TOUCH THE FOLLOWING OBJECTS WITH THE BLADE:
•
METAL POLES, ELECTRICAL WIRE, RUBBER, MASONRY, STONES, FENCES
!
WARNING
Do not cut if the metal blade is blunt, cracked or damaged.
Before starting to cut, check that there are no obstacles in the work area such as rocks,
metal poles or wound up wires. If you cannot remove these obstacles, mark them out
so that they do not come in contact with the blade.
Rocks or metal objects will blunt or damage the blade. Wires may wind on to the blade
head or may be deflected and cause injuries.