Seasoning The Griddle Plate; Overheat Protection; Cleaning, Care & Maintenance - NISBETS ESSENTIALS DA396 Manual De Instrucciones

Seasoning the Griddle Plate

Before using for the first time the cooking surface
needs to seasoned.
1. Ensure the cooking surface is clean.
2. Brush the surface with cooking oil.
3. Connect the appliance to the mains power
supply.
4. Turning on: Set the power switch to I position.
5. Set the thermostat to 50°C. The HEAT indicator
light turns on.
6. Once the set temperature is reached, the HEAT
indicator light turns off.
7. Turn the appliance Off and allow to cool before
wiping away any excess oil.
8. The appliance is now ready for use.
Cooking
Note: It is recommend the cooking
surface is lightly oiled before
cooking.
1. Close the plates.
2. Connect the appliance to the mains power
supply.
3. Turn the appliance on. The power indicator light
(green) illuminates.
4. Set the thermostat to the desired temperature
(50°C-300°C). The HEAT indicator light (orange)
turns On and the appliance begins to heat up.
Note: 200°C to 220°C is suitable for
general cooking.
5. When the set temperature is reached, the HEAT
indicator light turns Off.
Note: During use, the HEAT indicator
light will cycle on/off, indicating the
set temperature is being maintained.
6. Lift the upper plate and place the foodstuff on
the lower plate.
7. Lower the upper plate.
8. Turning off: After use, set the thermostat to
MIN position and power switch to O position.
DA396_ML_A5_v3_20210526.indb 5 DA396_ML_A5_v3_20210526.indb 5

Overheat protection

This appliance is featured with an overheat
protection. Should the temperature exceed safe
levels the appliance will automatically cut off power.
The thermal Cut-out switch is located on the rear of
the appliance. To reset the appliance after a sufficient
cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks,
using a blunt pointed instrument.
3. The appliance is now reset and can be used as
normal.
Cleaning, Care &
Maintenance
Warning:
Always turn off and disconnect the
appliance from the power supply
before cleaning.
Always allow the appliance to cool
before cleaning.
If grease is permitted to accumulate, it will begin to
carbonised into a hard substance that is extremely
difficult to remove. To prevent this follow the
cleaning steps below:
• Regularly remove excess grease or fat using a
cloth dampened with hot soapy water.
• Take care when using scrapers to remove
cooking residues as they can damage the
cooking surface.
• Dry thoroughly after cleaning.
• A Nisbets Essentials dealer or qualified
technician should carry out repairs if required.
For best performance, Nisbets
Essentials recommend that the
appliance is cleaned after each day
of operation.
Failure to clean the appliance
regularly may result in premature
activation of the thermal cut-out
switch.
UK
5
2021/5/26 13:06 2021/5/26 13:06