Uso; Measurement Reset; Automatic Casting Of The Anchor; Troubleshooting - Navimo Lofrans Galaxy503 Manual De Instalacion Y Uso

6 USE
Press the (ON) key to activate controls and to switch on the display lighting. The display lighting switches
off 30 seconds after the last command given (adjustable default time – see "BkLight Time").
Press key (UP) to control the anchor ascending.
Press key (DOWN) to cast anchor.
When any key is released (UP or DOWN) the corresponding action is stopped.

6.1 Measurement reset

To reset the measurement count simultaneously press the
seconds.
Measurement reset may also be performed in the Measurement menu by selecting "Yes" in the Reset
Measure row.
Measure
R e s e t M e a s u r e
U n i t s
R o p e _ C h a i n
E x i t

6.2 Automatic casting of the anchor

This function must be enabled in the Alarms and Functions menu (disabled by default).
Alarms & Functi
U p A l a r m
A u t o D o w n
L o a d D e f a u l t
E x i t
Select the row "Auto Down" and set the value at which the anchor must stop. Then press the
(DOWN) keys for at least three seconds. Once anchor casting has commenced, release the keys.
For safety reasons it is however possible to interrupt automatic descent by pressing any instrument key.
(ON) and the (UP) keys for at least three
N o
F e e t
O f f
3 . 0
O f f
N o
(ON) and

7 TROUBLESHOOTING

FAULT
Contametri mod. Galaxy 503/703
CAUSE

CORRECTIVE ACTION

Check the sensor electric
connections.
Check if sensor operates
Though UP or DOWN keys
properly. If not, replace it.
are pressed, the instrument
doesn't receive any signal from
Check the position of sensor
the magnetic sensor for more
and magnet on gipsy and their
than 5 seconds.
distance (3 mm).
Check the operation of electric
installation or anchor windlass.
The instrument's power Verify the battery charge or
supply voltage is lower than operation of the electrics
10V. system.
24