Cleaning And Maintenance - monzana 108509 Manual Del Usuario

8
Important warning when drilling:
Before drilling, make sure that there are no gas, water or power lines at the drilling site.
Installation by qualified personnel only. Be sure to pay attention to the condition of the
ground, as the fixing material supplied is not suitable for all types of ground. Ask your
supplier for suitable screws and dowels for the respective soil conditions.
The manufacturer accepts no liability for an improper wall-plug connection and any
resulting damage.

Cleaning and maintenance

If the shower no longer functions properly after some time, the spray or inlet or outlet
openings may be blocked. Regular maintenance and cleaning is therefore necessary to
ensure that the shower runs smoothly. It is quite normal for a deposit to form on the
shower as the water evaporates. Environmental influences also lead to dirt deposits.
The shower should therefore be cleaned at regular intervals. This increases the service
life on the one hand and effectiveness on the other. To remove deposits and dirt from
the shower, rub the housing or fittings with a soft damp cloth. Only use clear water
and never cleaning agents. Rinse the openings and the showerhead with clear water to
remove any dirt.
Do not use detergents or other solutions to remove the dirt. Carefully maintain the
unit. Check that moveable parts function properly and do not clamp, that parts are
broken or damaged in such a way that the function of the device is affected. Have
damaged parts repaired before using the unit. Many accidents are caused by poorly
maintained equipment.
Assembly(pages 22-23)
1. Now check the shower for tilt stability! It may be necessary to retighten the screws
or place washers between them.
2. To mount the showerhead, we recommend adding Teflon sealing tape to ensure
maximum tightness. Firmly wrap several rounds of the Teflon tape around
the rear part of the thread and then screw the showerhead with the tape into the
shower body. Make sure that you do not damage the thread when screwing it on. Too
much force will damage the thread and may cause unwanted water leakage. If the
showerhead has not yet been completely sealed, unscrew it and wrap the thread again
with Teflon tape.
If there are leaks in the head or foot piece please remove the respective parts, wrap
another 3-4 layers of Teflon tape around them and screw tight again.
www.DeubaXXL.de