Installation Procedure - Xerox Phaser 5335 Guia De Instalacion

Installation Procedure

The network expansion card goes on the controller board right above additional memory
(optional). If you purchased additional memory, install it before installing the network
expansion card. For information on how to install additional memory, refer to the 'User
Guide.'
Additional memory
Follow these steps when installing the network expansion card.
When uninstalling the network expansion card, use the reverse procedure described below.
1. Switch the power off by pressing the power
switch located on the front lower right of the
printer to the <O> position.
Unplug the power cord from the power
outlet and the printer.
2. Remove the cover plate on the rear side of
the printer. A coin may be used to loosen
any tight screws.
3. Remove the two screws that secure the
rear cover to the printer.
2
Network
expansion card