Oven; Stainless Steel Surfaces (On Some Models) - GE Cafe Manual Del Usario

Oven

Be sure electrical power is off and all surfaces are cool before cleaning any part of the range.
Control Panel and Knobs
Wipe the control panel after each use of the oven with
a damp cloth. For cleaning, use mild soap and water or
water. Polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleansers,
plastic scouring pads or oven cleaners on the control
Do not try to bend knobs by pulling them up or down
or by hanging a towel or other such loads. This can
damage the gas valve shaft.
The control knobs may be removed for easier cleaning.
With knobs in the OFF position pull them straight off the
stems.
The knobs can be washed by hand with soap and water
or in a dishwasher.
Oven Exterior and Cooktop Surface
Do not use oven cleaners, abrasive cleansers, strong
liquid cleansers, steel wool, plastic scouring pads, or
cleaning powders on the interior or exterior of the oven.
vinegar and water. Rinse with clean water and dry with a
soft cloth. When cleaning surfaces, make sure that they
are at room temperature and not in direct sunlight.

Stainless Steel Surfaces (on some models)

To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.
18
Not all knobs are interchangeable. To determine the
correct location of a particular knob, examine the back of
the knob. A knob with a label or two stem holes should
be replaced on the front panel first by matching the
shape of the knob holes to the shape of the control panel
stems. The remainder of the knobs having no labels and
only one stem hole can then be replaced on the front
panel anywhere there is a single stem.
Surface burner knob
abrasive cleaner and a sponge-scrubber for best results.
Spillage of marinades, fruit juices, tomato sauces and
basting liquids containing acids may cause discoloration
and should be wiped up immediately. Let hot surfaces
cool, then clean and rinse.
Cleaners with oxalic acid such as Bar Keepers Friend
Soft Cleanser™ will remove surface rust, tarnish and
small blemishes. Use only a liquid cleanser free of grit
and rub in the direction of the brush lines with a damp,
soft sponge.
To inquire about purchasing cleaning products
including stainless steel appliance cleaner or polish,
beginning of this manual.
Label
Stem
Stem holes
Knobs with two stem holes have
special locations
49-85233