King gates JET XL Instrucciones Y Advertencias Para La Instalación Y El Uso página 19

04. Fix the bracket in place using suitable plugs, screws and washers
(not supplied)
3.5.2 Installation of the front fixing
–
bracket
01. For the installation of the front bracket to the gate leaf, refer to
distance D (fig. 2).
02. Define the front bracket installation height in accordance with
fig. 4;
03. Fix the bracket to the solid section of the gate leaf.
3.5.3 Securing the gearmotor to the
–
fixing brackets
•
Secure the gearmotor to the rear bracket:
Note: if the rear bracket is not completely level, the back tilting
section can help compensate for any axis misalignments
between the two brackets (+/-5°).
+ 5°
- 5°
01. Secure the gearmotor to the bracket as shown in fig. 6, using the
screw, washer and nut supplied;
02. Fully tighten the nut and then loosen it again by approximately
1/10 of a turn, to allow a minimum clearance between the parts.
1
Fig. 4
Fig. 5
2
Fig. 6
•
Secure the gearmotor to the front bracket:
01. Secure the gearmotor to the bracket as shown in fig. 7, using the
screw and the washer supplied;
1
02. Fully tighten the screw;
• JET XL
Adjust the gearmotor opening and closing strokes:
01. Release the gearmotor as shown in fig. 8;
1
2
02. Remove the 2 screws underneath the handle and remove the
cover as shown in fig. 9.
1
2
3
Fig. 7
3
4
Fig. 8
2
Fig. 9
5