Troubleshooting Guide - ActiveAqua AAPW40 Manual De Instrucciones

ACTIVE AQUA SUBMERSIBLE PUMP COMPARISON CHART
Active Aqua Submersible Pump Comparison Chart
12
10
8
6
4
2
40
0
0

TROUBLESHOOTING GUIDE

SYMPTOM
The pump does not run
The motor repeats ON/OFF
without running pump. It stops
and does not restart
The pump runs with reduced or
no performance
The pump runs normally at the
beginning but the water flows
sluggishly or there is no water
400
160
250
550
200 400
GALLONS PER HOUR (LPH) VOLUME
CAUSE

Power is not turned on
Incorrectly plugged in
Bound impeller

Wrong voltage
The water intake or outlet pipe
is clogged with foreign matter

Wrong frequency
Impeller worn out
Low water level

Hose is too long or clogged
Air in the impeller chamber
AAPW1000
800
600 800
SOLUTION

Turn on the power
Plug in correctly
Remove foreign matter from impeller

Correct voltage
Clean out the intake and outlet

Correct frequency
Replace impeller
Ensure the pump is fully submerged

Shorten hose and/or clean out
To get rid of air, put pump into the
water. Turn the switch to "ON" and "OFF"
intermittently to clear air from pump
1000 1200
Pump
Model
AAPW10
AAPW80
AAPW55
AAPW40
AAPW25
AAPW16
AAPW40
7