What's In The Box; Installing The Cooktop - Furrion FGH4ZSA-SS Manual De Instrucciones

other combustible materials installed around the appliance
so as not to create a fire hazard.
The minimum horizontal distance(s) from
appliance to adjacent vertical combustible walls extending
above the top panel:
Item
A 2" Min. (51mm Min.)
B 2" Min. (51mm Min.)
NOTE: These distances shall be from the cutout of the
countertop.
WARNING
The minimum vertical distance to combustible material
above the range cooking top is 30" (762mm), provided the
overhead construction does not extend 13" (330 mm) from
the rear wall.
NOTE: If installing a range hood or microwave hood
combination above the cooking surface, follow the
range hood or microwave hood combination installation
instructions for dimensional clearances above the cooktop
surface.
Cabinet and counter cutout chart:
sides and back of
Dimension
C 143/8 " (365mm)
D 23½ " (597mm)
E 4" (102mm)
F 115⁄16" (50mm)
G 315⁄16" (100mm)
H 33/8 " (85mm)

What's in the Box

Make sure you have all the items in the packaging as listed
below. For missing item(s), contact your dealer.
● Single stainless steel gas cooker unit
● Flexible gas supply hose with a 3/8 " female flare fitting with
a 5/8 "-18UNF thread connection
● Butyl Tape
● 1 AA Battery
● User Manual
● Warranty Leaflet

Installing the Cooktop

WARNING
Gas supply pipe must be installed with clearance from
knives contacting or cutting gas lines.
IMPORTANT: Before finally fixing the cooktop into the
cabinet, ensure there is a ventilation hole for air circulation
around the cooktop in the cabinet. The location of the
ventilation hole can be located at the rear, sides or bottom of
the cabinet. The minimum diameter is 2" (50mm).
The clearance between the cooktop bottom to the
combustible materials is no less than 1" (25.4mm). Ensure the
countertop, surrounding materials and bonding agents have
a temperature rating of no less than 193°F (95°C) to avoid
deformation or discoloration.
1. Affix the roll of butyl tape (included in the cooktop
packaging) around the underside edge of the cooktop.
Remove the butyl tape protective film.
2. Connect a propane supply line with a 3/8 " Flare Female
connection to the cooktop in the upper left rear corner of
the cabinet. Tighten the gas line joint to the cooktop using
2 wrenches.
6