Product Use - Greencut GGT1200C Manual De Instrucciones

50

PRODUCT USE

ATTENTION: To avoid injury from accidental starts, always turn off the machine and disconnect it
from the power supply before moving it or making adjustments.
BEFORE USING
ATTENTION: Be sure to use an extension cable suitable for outdoor use (H05VV-F 2X0.75mm2)
attached to the power supply through a leakage protection system (RCD).
1. Place the safety harness on your left shoulder.
2. Connect the machine to the extension cable and then to the power supply.
START AND STOP
1. To start the brushcutter, press the safety lock button, while holding the lock button, press the on/off switch.
2. To stop the brushcutter, release the on/off switch.
USE OF THE METAL BLADE
-
Always cut from right to left.
-
A metal blade cuts better if it is kept at a distance of 1/3 of the edge. Use this area to cut bushes and
weeds. For cutting fresh grass, you can approach up to 2/3 of the blade tip.
- Always allow the nylon line / cutting blade to turn at maximum speed; do not work in such a way as to
overload the mower / brushcutter.
NOTE: Never run the brushcutter over the extension cord while it is running; make sure it is always
in a safe position behind your back.
USE OF THE SEMI-AUTOMATIC REEL
-
Nylon yarn uses more power. Please note that the rotation speed of the motor in operation will be 50%
higher than when using a metal blade.
-
The nylon cutter cuts the grass with the same power of rotation of the cord. If you try to cut the
grass by the length of the cord in one go, the rotation speed will decrease due to the resistance and
you will not be able to make a good cut. If there is more
resistance, quickly move the nylon mower away from the
grass, increase the rotation speed and cut small amounts
of grass in one go.
- To extend the reel string, run the engine at full speed and
hit the reel regulator on the ground. This will automatically
extend the nylon line.