Bayside LUCCI Aria CTC Manual Del Usuario página 8

Aria CTC Installation Instructions
INSTALL THE FAN ASSEMBLY TO THE MOUNTING BRACKET
•
After completing the electrical connection at the mounting bracket terminal block;
connect the remote receiver, and ceiling fan via the quick connector;
-
•
Ensure the earth wiring is secure and correct, by performing an earthing continuity test from the
fan's accessible metal body back to the earth terminal at the terminal block on the mounting
bracket.
Install the fan assembly to the mounting bracket (Fig.6)
•
There are 4 screws pre-installed on the mounting bracket:
Loosen two canopy screws with star washer (2) by half thread from the mounting bracket. (For L-
-
shape slot on canopy to be mounted).
Loosen two canopy screws (1) and remove from the mounting bracket.
-
•
Lift the hanging canopy of the fan assembly up to the mounting bracket and let the L-shape slot on
the hanging canopy go through the two canopy screws with star washer (2).
•
Turn the hanging canopy until it locks in place at the end section of the L-shape slot, ensure the
star washer are between the hanging canopy (3) and screw head. Secure it by tightening the two
canopy screws with star washer (2).
•
Secure and tighten the canopy screws (1) to the mounting bracket. The hanging canopy (3) shall
have 4 screws (1) & (2) in total. Avoid damaging the electrical wiring prepared previously when
hanging the canopy.
•
Finally attach the canopy cover (4) to the mounting bracket, secure it by pushing the hooks of the
canopy cover into the slot holes of the hanging canopy and turn it anti clockwise.
7 | P a g e
Fig. 6
V1.0 EU (2020/10)