Satco NUVO 65-501 Instrucciones De Instalación Y Seguridad

LED LINEAR HIGH BAY FIXTURE
Models: 65-501, 65-502, 65-503, 65-504, 65-505, 65-506, 65-507, 65-508
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING:
Risk of Fire or Electric Shock
• To avoid damage, falling, electric shock or fire, do not modify the fixture or replace
accessories without confirming with the supplier first.
• Only authorized, qualified personnel should install this fixture and should follow
the owner's manual. Any improper installation might cause failure,
electric shock, fire or other injury, damage or hazard.
• Disconnect power before installation or any maintenance of the fixture.
• Do not dismantle the fixture without the supplier's authorization.
• Do not touch the power supply when the fixture is operating.
• Thermal insulating material is not allowed to cover the fixture.
• Please keep away from the corrosive substance, and keep the fixture dry and clean.
• The external flexible cable or cord of this fixture cannot be replaced; if the cord is
damaged, the fixture shall be destroyed.
• The electrical fitting must be installed by a licensed electrician.
• For use in environments where an accumulation of non-conductive dust on the fixture may be expected.
IMPORTANT:
This product must be installed in accordance with the applicable installation code by
a person familiar with the construction and operation of the product and the hazards involved.
SPECIFICATIONS
Model Dimensions Watts
65-501
80W
65-502
65-503
2'
110W
65-504
65-505
165W
65-506
65-507
4' 225W
65-508
INSTALLATION
1. Thread the chain through the hook and
insert the hook into the slotted holes.
Hook the chain onto the ceiling anchor
(not included).
Chain
Hook
Ceiling Anchor
© Copyright 2019 Satco Products, Inc. 4/19
Volts CCT CRI
4000K
5000K
4000K
5000K
100-277V 80
4000K
5000K
4000K
5000K
2. Turn off power, then make wiring
connections with terminal caps.
See wiring diagram. Insert the terminal
caps and wires into the driver box.
Terminal Cap
Operating Temperature
Green (Ground)
-20°C to 45°C
TO SOURCE
WIRING DIAGRAM
IN
DIMMING
Black (Line)
FIXTURE
White (Neutral)
Purple (Dim +)
100-227V
Gray (Dim –)
3. Insert the wire terminal joint to the
wire entry. Installation is complete.
Satco Products, Inc.
Brentwood, NY 11717
OUT