Fan Assembly. Pgs - Craftmade Toscana TO52 Manual Del Usuario

5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Then slide hanging ball off of the downrod. [Refer
to diagram 1.]
Remove vice from safety cable by loosening the
screw and nut on the vice. Loosen yoke set
screws and nuts at top of motor housing.
diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod. [Refer to
diagram 2.]
Determine the length of downrod you wish to
use. Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod.
[Refer to diagram 2.]
Thread downrod into the motor housing yoke
until holes for pin in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed.
Tighten yoke set screws and nuts securely. [Refer
to diagram 2.]
Slide yoke cover, downrod accessory (if using
12in. downrod) and canopy over downrod.
to diagram 3.]
Thread safety cable and wires through hanging
ball and then slide hanging ball over
downrod--the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw. Insert stop pin into
top of downrod and raise hanging ball. Be sure
stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely. [Refer to
diagram 4.]
WARNING: Failure to tighten set screw (on
hanging ball) completely could result in the fan
becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
diagram 1
[Refer to
diagram 2
canopy
[Refer
downrod
accessory
diagram 3
stop pin
diagram 4
page 4
set screw
hanging ball
clip
pin
safety
cable
wiring
downrod
clip
downrod
hanging
stop pin
nut
vice
screw
yoke set screw
and nut
pin
yoke cover
motor
housing
set screw hole
ball