Maintenance; Service - Jotul F 500 ECO Instrucciones Para Montaje E Instalacion

ENGLISH

6.0 Maintenance

6.1 Cleaning the glass
The product is equipped with an air wash for the glass. Air is
sucked in through the air vent on the top of the product and
down along the inside of the glass.
However, some soot will always stick to the glass, but the
quantity will depend on the local draught conditions and
adjustment of the air vent. Most of the soot layer will normally
be burned off when the air vent is opened all the way and a fire
is burning briskly in the fireplace.
Good advice! For normal cleaning, moisten a paper towel
with warm water and add some ash from the burn chamber.
Rub it over the glass and then clean the glass with clean water.
Dry well. If it is necessary to clean the glass more thoroughly
we recommend using a glass cleaner (follow the instructions
on the bottle).
6.2 Cleaning and soot removal
Soot deposits may build up on the internal surfaces of the
fireplace during use. Soot is a good insulator and will therefore
reduce the fireplace's heat output. If soot deposits accumulate
when using the product, they can be easily removed by using
a soot remover.
In order to prevent a water and tar layer from forming in the
fireplace you should regularly allow the fire to burn hot in order
to remove the layer. An annual internal cleaning is necessary
to get the best heating effect from the product. It is a good idea
to do this in connection with the sweeping of the chimney and
flue pipes.
6.3 Sweeping of flue pipes to the
chimney
On certain free-standing fireplaces the top plate can be lifted
off and the pipe swept through the top.
Otherwise, flue pipes must be swept through the flue pipe
sweeping hatch or through the product's door opening. Then,
the baffle must be removed.
6.4 Inspection of the fireplace
Jøtul recommends that you personally inspect your fireplace
carefully after sweeping/cleaning. Check all visible surfaces
for cracks. Also check that all joints are sealed and that the
gaskets are in the correct position. Any gaskets showing signs
of wear or deformation must be replaced.
Thoroughly clean the gasket grooves, apply ceramic glue
(available from your local Jøtul dealer), and press the gasket
well into place. The joint will dry quickly.
6.5 Exterior maintenance
Painted products may change colour after several years
usage. The surface should be cleaned and brushed free of
any loose particles before new paint is applied.
Important! Never place anything on the top plate of the
stove. This could cause permanent damage to the paint
or enamel.

7.0 Service

Any unauthorised modifications to the product are prohibited!
Only original spare parts may be used!
Fig. 17
2
4
1. Exhaust deflector (2 pieces)
2. Baffle plate (2 pieces)
3. Rear burn plates
4. Side burn plates(2 pieces)
5. Ash grate
6. Ash grate holder
7.1 Replacing the baffle plate
Use tools with great care.
Fig. 18a Loosen the baffle plates
A
1. The support bar (A) that holds the baffles plate up is lifted
up and towards you before it is edged out of the stove. NB:
The two baffle plates are now loose and must be supported
so that they do not fall.
1
3
5
6
4
13