Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read
the instruction book carefully.
INTENDED USE:
The machine is intended for heavy chiselling
and demolition work as well as for driving and
compacting with the appropriate accessories.
For low temperatures, new power tool or
long-time storage, the machine reaches the
full impact rate only after a certain time.
This start-up time can be shortened by striking the
chisel in the machine against the floor one time.
Point chisel (For gravel)
Total length: 400 mm
Standard size: 30mm (Hexagon)
Cincel en punta
Cinzel de Ponta
Point Chisel
Flat chisel (For crushing asphalt, grooving
and squaring)
Total length: 400 mm
Standard size: 30mm (Hexagon)
Cincel plano
Cinzel Plano
Flat Chisel
1. DUSTPROOF COVER (SEE A)
Before chiseling vertically fit the Dustproof cover
over the drill bit.
Caution: Always wear eye protection with
this tool.
30
2. FITTING THE CHISEL (See B)
1) Insert the chisel into the chuck.
2) Drag the stop lever and rotate it to "Lock" position.
3. REMOVE THE CHISEL (See B)
1) Drag the stop lever and rotate it to "Unlock"
position.
2) Remove the chisel.
4. FITTING THE AUXILIARY HANDLE (See C)
For your personal safety we recommend using
the auxiliary handle at all times.
Attached the handle as shown in C. To adjust the
handle, loosen the knob on the auxiliary handle
by hand.
Rotate the handle around the handle collar and/
or rotate the handlebar to the desired position.
Tighten the knob fully.
Aflojar
Desapertar
Loosen
5. OPERATING THE ON/OFF SWITCH (See D)
Holding the Breaker with both hands and depress
the on/off switch then lock on button in for
operation (see D), To switch off just release the
on/off switch.
A
2
1
B
Apretar
Apertar
Tighten
C
D
Publicidad
