Setting Wireless Lan (Mf249Dw/Mf247Dw Only) - Canon imageCLASS MF249dw Manual Del Usuario

NOTE
• You cannot connect both the wired LAN and wireless
LAN at the same time. In addition, the machine is set to
the "Wired LAN" by default.
• When you connect to an unsecured network
environment, your personal information could be
disclosed to third parties. Please use caution.
• If you connect through a LAN in the offi ce, contact your
network administrator.
Checking the Router
Select the connection method to the wireless LAN. Select from
the following two methods depending on the router (access
point) that you are using.
●
There is a button.
This machine supports WPS
(Wi-Fi Protected Setup). You
can easily set up if your router
(access point) has a button,
and if the mark is on the
router.
If you are not sure whether or not your router supports WPS,
please see the manual included in the product, or contact the
product manufacturer.
●
There is no button.
If there is no button on your
router (access point), you
may manually select SSID and
complete the settings. In this
case, you need to remember
SSID and network key of your
router (access point).
See "1 Check SSID or Network
Key for a Wireless LAN Router/Access Point. " (P.11) to learn
how to fi nd out your SSID and network key.
To set up with the WPS PIN code method/To set up
manually:
User's Guide "Connecting to a Wireless LAN"
Setting Wireless LAN
(MF249dw/MF247dw Only)
Push Button Mode
1
Tap <Menu> in the Home Screen.
2
Tap <Network Settings>.
3
Tap <Wireless LAN Settings>.
If a screen appears asking whether to enable the wireless
LAN, tap <Yes>.
4
Read the message that is displayed, and tap <OK>.
5
Tap <WPS Push Button Mode>.
Wireless LAN Settings
SSID Settings
WPS Push Button Mode
WPS PIN Code Mode
Power Save Mode
Wireless LAN Information
6
Tap <Yes>.
7
Press and hold* the button until the lamp lights or
blinks.
You should press the WPS button within 2 minutes after
you tap <Yes> in step 6.
* The time that you should hold the button may vary depending
on the router you are using.
8
Wait approximately 2 minutes after the connection.
IP address is set during this period of time.
When an error message appears:
Tap <Close> to close the screen, check whether or not
the network key is correct, and then retry the settings.
If the access point cannot be detected even after
retrying, see the following.
User's Guide "When an Error Message Appears"
When checking the network connection:
You can check if the machine is properly connected to
the network by using a computer that is connected to the
network.
User's Guide "Viewing Network Settings"
To set IP address manually:
User's Guide "Connecting to a Wireless LAN"
Setting the Access Point Manually
1
Check SSID or Network Key for a Wireless LAN
Router/Access Point.
• Check the label on the Wireless LAN router.
• You can check the SSID or the network key using "Canon
MF / LBP Wireless Setup Assistant, " which is included in
the DVD-ROM supplied with the machine.
En
11