outwards (Fig. C). Attach the adapter cord to one of the arms using the holder (Fig. D). Place
the herb cultivator away from direct heat or steam and connect the adapter to a 230 V mains.
Application
Place herbs in containers onto the tray (Fig. E). For best performance, make sure that the tops
of the herbs do not reach more than 3 cm below the bar with LED light. For grown herbs, attach
the extensions to the arms (Fig. F). Regularly trim and water the herbs. Notice: If you mist the
herbs, do not spray water into the LED light area.
Timer with "day/night" mode
For growing herbs indoors, use the timer with "day/night" mode that operates in alternating
cycles of 16 hours on and 8 hours off .
3 s
16
8
Start the timer by placing your fi nger on the touch control button for about 3 seconds. The LED
light will switch on and the green indicator lamp will go on. From this time the light will be
switched on for 16 hours ("day" phase) , then switches off and remains switched off for 8 hours
("night" phase). After the whole "day/night" cycle (24 hours) has elapsed, the timer automati-
cally starts another "day/night" cycle.
Switch off the timer with the "day/night" cycle by placing your fi nger on the touch control
button for about 3 seconds.
Quickly switching off /on the LED light
1 s
For quickly switching the light off (in the „day" phase of the cycle) or on (in the „night" phase of
the cycle), briefl y touch the control button with your fi nger and the green indicator lamp will
5